Headlights Pair Set for 02-09 Chevy Trailblazer

Headlights Description:

A new pair of headlights from ours allow you to see the road in front of you clearly during the night and in any bad weather that may arise.

Gives you and your family safer nighttime driving.

Makes your car looks newer.

See road markings and traffic sighs better.

Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.

A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only is your own safety at risk, but the safety of others is as well.

Black Housing Clear Lens

DOT & SAE for street legal

Great Replacement or upgrade for factory headlights

Waterproof on rainy days

Bulbs are NOT included, need to reuse original bulbs

To fit for models below:

2006-2009 Chevy Trailblazer Full Width Grille Bar

2002-2005 Chevy Trailblazer Headlight Full Width Grille Bar

2006 Chevy Trailblazer EXT Full Width Grille Bar

2002-2005 Chevy Trailblazer EXT Headlight Full Width Grille Bar

Low Beam Bulb Type: 9006 HB4

High Beam Bulb Type: 9005 HB3

Package included:1 pair set of Left Driver Side + Right Passenger Side Headlights Headlamps

Note:

Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The center lines of the headlights should not be any higher than 3.5 feet above the ground.

1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

5. Test your results.

California Residents: Prop 65 Warning

WARNING: Cancer and Reproductive Harm

Visit: www.p65warnings.ca.gov