OE Style Headlight Assembly for Dodge Caravan 01-07 / Chrysler Town & Country 2001-2007(Fits Short 113" Wheelbase ONLY)

SPECIFICATION AND FITMENT

Tested In Simulated Rain/Humidity/Shock

High quality aftermarket replacement headlights

Professional installation is highly recommended

Vehicle fitment:

• Chrysler Town & Country 2001 2002 2003 2004
• Chrysler Town & Country 2005 2006 2007(Fits Short 113" Wheelbase ONLY)
• Will not fit long 119" wheelbase
• Chrysler Voyager 2001 2002 2003
• Dodge Caravan 2001 2002 2003 2004 2005 2006 2007
• Dodge Grand Caravan2001 2002 2003 2004 2005 2006 2007

Bulb type:

• High Beam and Low Beam Headlight Bulb #: 9007（not included）
• Front Sidemarker Light Bulb#: 3157-SCK, 3157NA（not included）
• Front Turn Signal Light Bulb#: 3157-SCK, 3157NA（not included）

Working headlights are a critical component of any vehicle

• Undo the screws, clips, or retainer springs that hold the headlight in place.
• Disconnect the wiring from the assembly.
• Detach the headlight from the vehicle to replace it with a new one.
• Fit in the new headlight assembly.
• Fix the new headlight into place and make sure that the screws, clips, or retainer springs are sealed.
• Reconnect the wiring that was unplugged from the assembly.
• Put back the grille and other components that you removed. Seal them back into place.
• Test the new assembly.

• Have the headlights on your car been dimmed by abrasion from road debris?
• Are your factory headlights not bright enough?
• Are your headlights yellowed and discolored from the sun and elements?
• Do faulty headlights make you afraid to drive at night?

If your headlight assembly fails to provide satisfactory performance, you should consider changing it ASAP.

A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous, which not only puts your safety but also the safety of others at risk.

See farther. See wider, See better

A new set of headlights from YITAMOTOR will allow you to see the road in front of you clearly at night and in any bad weather that may arise.

Packing List :
1 Pair of Headlights (Driver & Passenger Side)

Please Note :
1.The high beam / low beam adjusting lever already pre-adjusted. If you 'ld like to re-adjustable it, will need use with professional tools.

2.Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.
2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. 【Test your results】